DIY ENERGY AUDIT: How to Do Your Energy Audit in Your Home

Have you been getting really high utility bills even though you’ve invested in all the right energy efficient technology? Are you confused about where you’re losing energy? A simple way to find out is to conduct an energy audit on your home. An energy audit involved finding out where your house is losing energy, and where you can save that from happening. Although you can get a professional home energy audit done, you can also try doing it yourself by carefully examining your house and spotting any problems.

This article gives you 4 different ways of carrying out your energy audit.

Starting off

When you start examining your house, make sure you make a checklist of all the areas that you inspected, and the problems that you found in some areas. Keeping track will help you in prioritizing energy efficiency upgrades. If your home has been newly constructed, do not make the assumption that there are no ways of saving energy. You will still need to invest in technology that caters to energy saving.

1-  Identify air leaks

This is one the most basic ways of preventing energy loss. Make sure you visit each and every room in your house and list down all apparent sources of drafts or air leaks. The most blatant places where air leaks could happen are door frames, wall junctures, and baseboard rifts. Once you’re done inside, you should repeat the entire process outside of your house. You could also consider checking out the U.S. Department of Energy, which has a lot very detailed and helpful guidance about recognizing air leaks and could help you identify some places you might have overlooked.

2-  Seal all air leaks

To seal the air leaks you found, you need to plug and caulk the holes or, use penetrations for pipes, wiring, electric outlets, and faucets. Implementing caulk and weather-stripping are your two best ways of sealing air leaks.

3-  Examining Heating and Cooling Equipment

This needs to be done either annually, or as prescribed by the manufacturer. If your house has a forced-air furnace, inspect your filters and reinstate them. Usually, they need to be changed around once a month or two, particularly if their usage is high. A good practice is to employ a professional to come and inspect plus clean your equipment at least once during the year.

If your unit dates to 15 or more years, it’s time for you to think about replacing the entire system with something that is more modern and energy efficient. This would reduce the power being consumed by a considerable proportion, primarily if your old equipment was in bad condition.

Examine your ductwork for any dirt streaks, particularly near the seams. These signify air leaks, and they need to be blocked by using duct mastic.

4-  Considering Ventilation

While sealing your house, be cognizant of the risk of indoor air pollution combined with combustion appliance back drafts. Back drafting means different combustion appliances and exhaust fans found in the house competing for an air source. Combustion gases could be pulled back into a living space by an exhaust fan, creating an unhealthy environment in the home. If there is fuel being burnt in the house for heating, make sure the appliance has enough air supply.

These are 4 very simple ways to perform an energy audit on your own. Make sure that you do this every month as there might be new air leaks, or there could be appliances that need upgrading. By just investing a little bit of time in making your home more energy efficient, you can save yourself a lot of money from utility bills!

Competitive Energy Quote

Thank you for reading!